Leica Biosystems LPC Software installation - Manual (Page 74)

74 Software Installation Manual, Revision 2 - 03/2010
1.3 Overview
The LabeLase® Producer CL software allows you to configure, create and
print cassettes directly from your Windows computer. The program pro-
vides basic features for operator level personnel to open and print layouts
as well as more advanced features accessible to supervisory personnel for
configuring and maintaining the printer.
Operator mode
The operator mode is the native mode of the software. When the program
starts, it is in the operator mode and the more advanced features are not
available.
In this mode, the operator can perform the following operations:
• Open a layout that is stored on hard disk
• Enter text into the layout’s data fields (if enabled)
• Enter a starting serial number (if enabled)
• Enter the quantity of cassettes to print
• Begin the print operation
Supervisor mode
The supervisor mode is provided to allow more advanced control of the cas-
sette printing process. To enter this mode, pull down the File menu and se-
lect Supervisor. You will be asked to supply a password to enable the super-
visory features. When the program is first installed on your computer, no
password is set. It is strongly recommended that you create a password
soon after installing the software to prevent unauthorized personnel from
accessing the advanced features of the program. In the supervisor mode,
the following operations can be performed:
All of the things the operator can do, plus…
• Create and edit a layout
• Configure the cassette printer
• Change the supervisor password
• Set the program’s units of measure
1. Introduction