Leica Biosystems IPS - Manual (Page 26)

24 Instructions for Use V 1.9 RevD - 05/2013
Carefully pull out the transport anchor (27) of
foam that protects the print head by pulling it to
the right.
Carefully remove any adhesive tape remnants.
• Check instrument for damage (do not switch
on in the case of damage!).
• Check delivered accessories for completeness
according to purchase order.
• Remove the transport anchor (27, Fig. 12 ).
• Carry out the following installation steps:
• Install the accessories.
• Insert shielding glass (
Fig. 16 ).
• Insert the flash bulb.
• Connect to the power supply.
• Exchange the cartridges.
• Establish data connection to PC.
• Install printer driver.
• Fill the magazines with specimen slides.
• Run a test print.
Fig. 12
27
4.3 Installing the printer
When unpacking the printer, at least
two people (one person on each side
of the printer) are required to lift the
printer out of the box and place it onto
the laboratory bench.
4. Instrument Setup