beautypg.com

Assembly and lubrication, Assembly and lubrication check list, Lubrication maintenance – Landoll ICON 1632RS Grader User Manual

Page 19: Storage, Chapter 4

background image

4-1

Chapter 4

Assembly and Lubrication

Assembly and Lubrication Check
List

1.

Install and pin pivot frame to tongue frame.

2.

Pin rear frame to center pivot frame

3.

Attach grader hitch and assure proper movement.

4.

Install pivot pins, and insert all retaining clips.

5.

Install lift/tilt pivot cylinders. Install all cylinder pins
and retaining clips.

6.

Install box ends and components. Fold and check to
assure they function properly.

7.

Install axle and wheel components. Visually inspect
tires.

8.

Route hydraulic lines and tighten.

9.

Install safety lighting components, route wiring, and
install plug retainer. Cycle and check lighting system
with 12 volt system tester.

10. Lubricate all moving components with high temp

grease.

11. Fill hydraulic systems with Mobil 424 hydraulic oil

using hydraulic pump, activate all moving parts and
bleed air from the system. Hold 3000 psi. hydraulic
pressure against all cylinders, fittings, and hoses.

12. Check hydraulic components for leaks.

13. Recheck that all retainers are installed.

14. Assure the rear steer components function properly.

15. Clean and touch up paint the machine.

16. Attach operators manual and container.

17. Apply the safety, operations, and lube identification

decals. Attach plastic envelope with warranty info,
and this check list, at the front of the hose holder.

18. For ease of transporting, assure that the blade is

level, and in the transport position before leaving
shop.

Lubrication Maintenance

1.

Table 4-1 specifies the number and the period of
lubrication points on the 1632RS Grader. Proper
maintenance of your machine will, under normal
operating conditions, help to keep it operating at or
near its peak performance for an extended period of
time. Proper maintenance is also a condition of
keeping your warranty in good status (See
Figure 4-1.)

2.

When lubricating the 1632RS, SAE multi-purpose EP
grease, or EP grease with 3-5% molybdenum sulfide
is recommended. Wipe soil from fittings before
greasing. Replace any lost or broken fittings
immediately.

3.

Regular lubrication will extend service life,
particularly in severe operating conditions.

Storage

1.

The service life of the 1632RS Grader will be
extended by proper off-season storage practices.
Prior to storing the unit, complete the following
procedures:

a.

Completely clean the unit.

b.

Inspect the machine for worn or defective parts.
Replace as needed.

c.

Repaint all areas where the original paint is worn
off.

d.

Grease all exposed metal surfaces of shanks,
points and discs.

e.

Apply a light coating of oil or grease to exposed
cylinder rods to prevent them from rusting.

f.

Lubricate each point of the machine as stated in
“Lubrication Maintenance” on page 4-1.

2.

Store the unit in a shed or under a tarpaulin to protect
it from the weather. The ground tools and tires should
rest on boards, or some other object, to keep them
out of the soil.

This manual is related to the following products: