Landoll ICON 819 - Manual (Page 8)

Foreword
Literature Information
This information should be stored in the
literature holder located on the machine.
This manual contains safety information,
operating instructions, lubrication and
maintenance information.
Some of the photographs or illustrations in the
publication show details that can differ slightly
from your personal machine. Shields and covers
may have been removed to allow for
illustrations.
Constant improvement and knowledge of
product design may cause changes to your
personal machine that is not listed in this manual.
Read, understand, and keep this manual with the
machine to aid in repairs, adjustment, service and
parts identification.
Whenever a question arises regarding your
machine, or this manual, please contact Product
Support for assistance.
Safety
The safety section of this manual lists basic
safety precautions. In addition, this section
shows the location of safety signs and decals
used on this machine.
Read and understand the basic precautions
listed in the safety section before operating or
performing lubrication, maintenance or repair
work on this machine.
NOTE: Before any service or repair work is
performed, make certain that all safety stops
are in place.
Be certain to remove all safety stops when
repairs are complete.
Operation
This operation section is a reference guide for
the new operator and a refresher for the
experienced operator. Operating techniques
shown are basic, skill and technique will increase
with knowledge and usage of the machine.
Maintenance
The maintenance section is a guide to
machine care. The illustrated step by step
procedures covers the most important of the
maintenance schedule. Regular routine
lubrication is described in less detail.
Maintenance Intervals
Normally, all lubrication should be on a
daily basis. However, certain locations only
require lubrication on a weekly basis or
require a specific quantity. These locations
will be marked clearly, showing and
describing requirements.
Under extremely severe, dusty/wet/sandy
conditions, or if the haul is long and rough,
more frequent lubrication and inspection of
highly stressed areas is recommended.