Landoll ICON 819 - Manual (Page 5)

A quality, high temperature grease should be used when lubricating the machine. Most areas of lube are
scheduled daily, (8 to 10 hrs. of running). There are 27 grease zerks on the 800 Series that should be greased
daily. There are also 2 zerks per axle that are greased weekly with 3 pumps of grease. (Reference to their
location is listed in the Grease Guide, at the front of this book.
All bolts are torqued at the factory during assembly. After 24 to 36 hours of running, the Dealer service
should recheck the torque on bolts, wheel, axle, and pin retainers. Each time the machine is greased, the
operator or maintenance should look at these areas and the bolts involved, to be sure none are working loose.
After each 1000 hours of operation with the machine, the hitch, wheel, axle and pin retainers should be re-
torqued, per the torque value chart in this manual. The axle jam nuts should be adjusted to a snug fit, seating
the bearings, then locked in place with the outside star washer.
For safety, identification, and general information, all missing or damaged decals on the machine should be
replaced.
The ICON earthmovers have the interior of the bowl painted with a carbon base graphite paint, which
rejects dirt. Should that paint wear off over a period of time, replacement paint may be ordered by the gallon
through the original Dealer.
The cutting bits for the the earthmover are available through ICON. The bevel is reversed as compared
to the normal bits, in order to make loading easier in tough ground. The reverse bevel will not have the same
longevity in wear as the normal bevel. Replacement bits may be ordered from ICON, or your Dealer. Refer
to the cutting edge section of this manual for size and part numbers. A new set of bits and side router edges
have been added to the available options. The center stinger bit is 3 inches longer, to allow a more
aggressive cut, and the side bits are 4 inches longer, to aid in loading by slicing the ground on the out
edges.
All retaining pins have replaceable bushings. Watch the pin locations in action to review for loose and
worn operation.
All 800 series machines come standard with a ride cushioning accumulator. This unit is charged to 650 psi
and is located inside the access door on the main frame. (see photos)
The timing of the loaded machine is critical to it’s performance. On a 2 valve setup, it is important that
the gate and push off wall work as they should. Adjustments to the timing can be made at the sequence
block on the tongue of the machine. (Refer to the timing chart in the manual for instructions).
Remember, the longevity of your machine will depend on proper operation and maintenance.
Scheduled Maintenance
Warning!
To prevent a hazardous situation, which if not avoided can result in injury
or death, read and follow these instructions!
•
Read and understand the operator’s manual before operating the machine. Allow
no one to operate the machine before reading the manual and being instructed on the
proper operation.
•
Before servicing the machine, block the wheels, shut the tractor off, set the
brakes, and remove the key. If working under the machine, block the machine up for
a safe and secure working area. Apply any safety stops provided.
•
When working with hydraulic lines, cylinders, or fittings, wear protective clothing
and safety glasses to guard against high pressure oil leaks.
•
Do not allow anyone on, or near the machine while it is running or in motion.
•
Do not operate the machine on a steep incline or slope that could create an
imbalance or rollover.