Landoll WFPC38-52 Wing Float Pulverizer - Manual (Page 48)

4-2 F-661-R2
MAINTENANCE
Hydraulic Fitting Torque
Specifications
TORQUE SPECIFIED IN FOOT POUNDS
PARKER® BRAND FITTINGS
AEROQUIP® BRAND FITTINGS
GATES® BRAND FITTINGS
37 degree JIC, ORS, &ORB (REV. 10/97 )
This chart provides tightening torques for general purpose applications when special torques are not specified on process or drawing.
Assembly torques apply to plated nuts and capscrews assembled without supplemental lubrication (as received condition). They do
not apply if special graphite moly-disulfide or other extreme pressure lubricants are used. When fasteners are dry (solvent cleaned)
add 33% to as received condition torque. Bolt head identification marks indicate grade and may vary from manufacturer to
manufacturer. Thick nuts must be used on grade 8 capscrews. Use value in [ ] if using prevailing torque nuts
Dash
Size
37 Deg.
JIC
O-ring
(ORS)
O-ring
boss
-4 11-13 15-17 13-15
-5 14-16 --------------- 21-23
-6 20-22 34-36 25-29
-8 43-47 58-62 40-44
-10 55-65 100-110 58-62
-12 80-90 134-146 75-85
-16 115-125 202-218 109-121
-20 160-180 248-272 213-237
-24 185-215 303-327 238-262
-32 250-290 -------------- 310-340
Dash
Size
37 Deg.
JIC
O-ring
(ORS)
O-ring
boss
-4 11-12 10-12 14-16
-5 15-16 --------------- 16-20
-6 18-20 18-20 24-26
-8 38-42 32-35 50-60
-10 57-62 46-50 75-80
-12 79-87 65-70 125-135
-14 -------------- -------------- 160-180
-16 108-113 92-100 200-220
-20 127-133 125-140 210-280
-24 158-167 150-165 270-360
Dash
Size
37 Deg.
JIC
O-ring
(ORS)
O-ring
boss
-4 10-11 10-12 14-16
-5 13-15 --------------- ---------------
-6 17-19 18-20 24-26
-8 34-38 32-40 37-44
-10 50-56 46-56 50-60
-12 70-78 65-80 75-83
-14 -------------- 65-80 --------------
-16 94-104 92-105 111-125
-20 124-138 125-140 133-152
-24 156-173 150-180 156-184
-32 219-243 -------------- --------------