Landoll WFPC38-52 Wing Float Pulverizer - Manual (Page 24)

2-10 F-661-R2
ASSEMBLY
Hydraulic Installation

WARNING
Remove Fitting Caps prior to installing Fittings.
NOTE
The Magnet provided is used to prevent hoses from
dragging with drawbar extended.
Assemble the Magnet and related components to the
hoses. Position halfway between drawbar assembly and
hose support.
Figure 2-9: Hydraulic Installation
Escaping fluid under pressure can be nearly
invisible and have enough force to penetrate the
skin causing serious injury. Use a piece of
cardboard, rather than hands, to search for
suspected leaks. Wear protective gloves & safety
glasses or goggles when working with hydraulic
systems.
Hose
Support
Handle
Hose Clamp
Magnet
HHCS,5/16-18 x 2-1/4
Flat Washer,5/16
Elbow,08MOR x
08FJS x 90°
Remove
Fitting Caps
Female Coupler
TIGHTENING PROCEDURE FOR
JIC 37° SWIVEL FEMALE NUTS
1. Check flare and seat for defects.
2. Lubricate the connection.
3. Install hoses without twists.
4. Hand tighten until connection bottoms.
5. Using 2 wrenches to prevent twisting,
rotate the swivel nut 2 wrench flats
(1/3 turn).
6. For reassembly, follow the same
procedure but tighten only 1 wrench
flat (1/6 turn).
Drawbar Assembly
TIGHTENING PROCEDURE FOR
SWIVEL O-RING FITTINGS
1. Lubricate o-ring and install the fitting
until the metal washer which backs up
the o-ring contacts the face of the boss.
2. Then orient the fitting by turning
counterclockwise up to 1 turn.
3. Tighten the lock nut using 50-60 foot
pounds torque.