Landoll BPSB6 Till-N Seed - Manual (Page 21)

OPERATION
2-7
Seed Rate
Refer to Seed Chart on the Front Seedbox Cover to
determine range for Seeding Rate. It should be used as a
general guide only, because of seed size variation and
cleanliness. A more accurate Seed Rate can be
determined by Calibrating the Seeder, see Seed Rate
Calibration in this section.
• To install sprockets for the required range, remove the
Klik Pin and change the Driver and Driven Sprockets
accordingly. Also, refer to decal on the inside of the
Transmission Cover.
Disengage or Engage Seeding:
• To disengage seeding, remove Klik Pin and store it in
the hole provided in the end of the shaft.
• To engage seeding, re-install the Klik Pin into the
sprocket and shaft.
Figure 2-7: Seed Rate
Sprocket Storage
Remove Klik Pin
to change Sprocket
Low-Range 10 Tooth
Mid-Range 13 Tooth
High-Range 19 Tooth
Driver Sprocket
Remove Klik Pin
to change Sprocket
Low-Range 37 Tooth
Mid-Range 23 Tooth
High-Range 23 Tooth
Driven Sprocket
Engage Position
Disengaged Position
Klik Pin