Landoll 1806/1806-1 FS, FSC, FSB Series Flail Shredder - Manual (Page 12)

987rev701 8J306 Page 6A
MAINTENANCE·
Check oil level in gearbox before using. On the side of the gearbox are two plugs. Fill and maintain to
lower level plug with proper grade of lubricant. Where temperatures are above 32° F. (0° C.) use SAE
Grade 140EP. Below 32° F. (0° C.) use SAE Grade 90EP.
Grease the implement drive assembly including the universal joint crosses and the telescoping tube and
shaft. Compress the two halves of the drive line exposing the fitting. Do this daily.
Grease other bearings lightly every 40 to 50 hours of operation. It is necessary to block up the
machine and get undemeath the machine to grease the two center bearings on the flail assembly.
Block the wheels to prevent the machine from moving.
A
Do not depend on the hydraulic cylinder to support the machine while you are under it.
It could collapse and fall on you causing severe injury or even death.
Repack wheel bearings once a year.
Check and retighten all bolts periodically.
Check belt tension and alignment frequently. New belts stretch rapidly in the first few hours of use.
See instructions on the next page for proper belt tension and alignment.
Check tire inflation pressures at least once a week. Maximum pressure 20 psi; minimum pressure 10
psi.
Check for blade breakage if there seems to be excessive vibration. Replace any broken blades in pairs
as described on page 5.