Landoll 175116 Trunnion Bearing Retrofit Kit - Manual (Page 2)

1-2 Brillion Farm Equipment F-715
Landoll Corporation
INSTALLATION INSTRUCTIONS FOR
Trunnion Bearing Retrofit Kit P/N 174940
WFP22-36 built between September 2012 and January 2013 with 4” X 6” front frame tube

CAUTION
• Identify the parts listed below.
• Place the Wing Float Pulverizer in a suitable area
to work with the frame while the wings are
unfolded.
• Make sure all hydraulic pressure is neutralized.
NOTICE
NOTE
The Retrofit procedure is the same for both kits, the only
difference being the Right/Left Hand Hangers, Items 15
and 16, in the parts table. This is due to the Front Frame
Tube dimension.
Do not work on or under this machine unless
securely
blocked and supported by a hoist or
tractor or by other sufficient means!
Understand the procedure before doing the work.
Use proper tools and equipment.
Kit 174940 - Parts List
For machines built between September 2012 to January 2013 with 4” X 6”
front frame tube
ITEM PART NUMBER DESCRIPTION QTY
174940 KIT, TRUN BRG HNG RETRO
1 1-654-010061-06 SCREW,HXCP, 3/4-10UNCX2-1/4GR5 12
2 1-861-010034-17 WASHER, LKG, HLCL SPR, 3/4 12
3 1-861-010034-21 WASHER, LKG HEL SPRG 1IN 6
4 1J136 SPRAY CAN RED PAINT 1
5 137943 SCREW,HEX CAP 1-8UNCX2-1/4GR5 6
6 140477 BEARING, DISC 1.775 ID ASSY 6
7 140479 MOUNT, TRUNNION BEARING 12
8 154185 WASHER, 3/8 THICK 1” ID 6
9 154186 WASHER, FLAT TOP 6
10 171738 WASHER, SHIM 11 GA, 1.79 ID 12
11 171739 WASHER, SHIM 14 GA, 1.79 ID 6
12 173119 SHAFT-STUB, AXLE, WELDMENT 6
13 174879 BOLT ON BEARING HANGER 2
14 174880 PLATE-BEARING MOUNT 2
15 174937 HANGER, RH SUB-WELD (4” X 6”) 1
16 174942 HANGER, LH SUB-WELD (4” X 6”) 1
17 528934 REFLECTOR - YELLOW 2
18 9D674 HOSE TIE - 8” 4