KD Scientific EZFLOW 2040 - Manual (Page 17)

15
KDS EZFlow 2040
Screen 9
1) Press to enter MODE SETTING
status.
2) Select item No.0 SELECT PRESETS;
3) Press to enter (screen 8).
4) Use or to select data memory
from 0-9 for preferred infusion mode.
5) Press to confirm selection, and
then return to main screen.
6) If preset infusion mode is not selected,
press to return to main screen.
MENU
ENTER
SET
ENTER
SET
EXIT
CLEAR
Operation Settings and Procedures
(Continued)
1. SELECT PRESETS
1) Press to enter MODE SETTING
status.
2) Press or to select item
No.1 PRESET PROGRAM
3) Press to enter (screen 9). Press
or to select memory 0-9 from
the directory to store pre-programmed
infusion rate and volume.
4) Press to confirm selection and
enter (screen 10).
5) Press or to set the desired infu-
sion rate, then press to confirm.
6) Press or to set the desired vol-
ume limit, then press to confirm
and return to memory directory screen.
Pre-programmed infusion combination
will be stored in the memory.
7) Press to return to MODE
SETTING Screen 10 screen.
8) Press again to return to main
screen.
MENU
ENTER
SET
ENTER
SET
ENTER
SET
ENTER
SET
EXIT
CLEAR
EXIT
CLEAR
2. PRESET PROGRAM
Screen 8
Screen 10