JUMO 902815 Dtrans T100 Screw-In RTD Temperature Probe Without/With Transmitter Operating Manual - Manual (Page 4)

4
1 Introduction
The screw-in RTD temperature probe, which has a compact design,
consists of a protection tube with an integrated temperature sensor,
a process connection, and an attached housing for the transmitter
electronics. The built-in programmable 2-wire transmitter converts
the resistance value into a current signal.
The screw-in RTD temperature probe with programmable 2-wire
transmitter is used for measuring temperatures from -50 to +150 °C
(-58 to +302 °F), with an extension up to 260 °C (500 °F).
The range, fine calibration, measuring circuit monitoring etc. can all
be configured through the setup program.
The 4 to 20 mA or (reversed) 20 to 4 mA output signal that is
provided is linear with temperature. The instrument is designed for
industrial application and complies with the European standards for
assuring electromagnetic compatibility (EMC).
The transmitter must be protected from temperatures above
85 °C!
Product with an integrated transmitter is not intended for
export to the USA!