JUMO 902815 Dtrans T100 Screw-In RTD Temperature Probe Without/With Transmitter Operating Manual - Manual (Page 13)

13
4 Setup program
4.5 Connection arrangement
Use
- The PC interface with USB/TTL converter is only designed for
service use over a limited period, such as the transfer of setup
data.
- It links JUMO devices to a PC through an electrically isolated
connection. The RJ-45 Western plug is specially adapted to
JUMO devices, and is not suitable for third-party equipment.
Make the connections for the setup program as described below:
1. First connect the USB type A plug (a) to the PC/laptop and then
connect the USB type B plug (b) to the PC interface with USB/
TTL converter (c).
This ensure a safe grounding on the PC/laptop side.
2. Connect the RJ-45 Western plug (d) of the configuration cable
(e) to the PC interface with USB/TTL converter (c) and the
M12 × 1 socket (f) to the JUMO Dtrans T100 (g).
3. Connect the M12 × 1 socket (i) of the PVC connecting cable (j)
to the M12 × 1 plug (h) of the configuration cable (e).
4. Connect the 8 to 35 V DC voltage supply to the PVC
connecting cable (j).
A
Do not confuse the RJ-45 socket with an ISDN or network
connection.
H
Remove the modular cable (not required for this setup,
therefore not shown in the diagram) of the PC interface with
USB/TTL converter, including two adapters (socket and
plug) – will be needed for other devices.