JULABO F38-ME Beer Forcing Test Refrigerated/Heating Circulating Bath - Manual (Page 12)

Safety notes for the user
12
3.3. Safety recommendations
Follow the safety instructions to avoid personal injury and property damage. Also, the
valid safety instructions for workplaces must be followed.
 Only connect the unit to a power socket with an earthing contact (PE – protective
earth)!
 The power supply plug serves as a safe disconnecting device from the line and
must always be easily accessible.
 Place the unit on an even surface on a base made of nonflammable material.
 Do not stay in the area below the unit.
 Make sure you read and understand all instructions and safety precautions listed in
this manual before installing or operating your unit.
 Set the excess temperature safety installation at least 25 °C below the fire point of
the bath fluid.
 Observe the limited working temperature range when using plastic bath tanks.
 Never operate the unit without bath fluid in the bath.
 Pay attention to the thermal expansion of bath oil during heating to avoid
overflowing of the fluid.
 Prevent water from entering the hot bath oil.
 Do not drain the bath fluid while it is hot!
Check the temperature of the bath fluid prior to draining (e.g., by switching the unit
on for a short moment).
 Use suitable connecting tubing.
 Avoid sharp bends in the tubing, and maintain a sufficient distance from
surrounding walls.
 Make sure that the tubing is securely attached.
 Regularly check the tubing for material defects (e.g., for cracks).
 Never operate damaged or leaking units.
 Always turn off the unit and disconnect the mains cable from the power source
before performing any service or maintenance procedures, or before moving the
unit.
 Always turn off the unit and disconnect the mains cable from the power source
before cleaning the unit.
 Always empty the bath before moving the unit.
 Transport the unit with care.
 Sudden jolts or drops may cause damage in the interior of the unit.
 Observe all warning labels.
 Never remove warning labels.
 Never operate units with damaged mains power cables.
 Repairs are to be carried out only by qualified service personnel.
 Some parts of the bath tank and the pump connections may become extremely hot
during continuous operation. Therefore, exercise particular caution when touching
these parts.