INFICON BCG450-SD ATM to Ultra-High Vacuum Triple Gauge (DeviceNet) - Manual (Page 18)

18
tira40e1 (2005-04) BCG450SDv1.cp
Attribute
ID
Access Rule NV/
V
Name DeviceNet Data
Type Description of
Attribute Semantics of Values
7 Get V Status BYTE Alarm and Warning
State of this object
instance Always zero, because Alarm
and Warning Trip Points are not
implemented
10 Get NV Full Scale INT or specified
by Data Type The Value of Full
Scale for the sen-
sor. The value of attribute Value
corresponding to the Full Scale
calibrated measurement of the
sensor.
[default] = maximum allowable
value for the Data Type
25 Set NV Safe State USINT Specifies the be-
havior for the Value
for states other
than Execute → "Semantics" section below.
[default] = 0
26 Set NV Safe Value INT or specified
by Data Type The Value to be
used for Safe State
= Safe Value → "Semantics" section below.
[default] = 0
32 Get NV Overrange INT or specified
by Data Type Specifies the hig-
hest valid Value The value above which attribute
Reading Valid is set to invalid.
[default] = maximum allowable
value for the Data Type
33 Get NV Underrange INT or specified
by Data Type Specifies the
lowest valid Value The value below which attribute
Reading Valid is set to invalid.
[default] = minimum allowable
value for the Data Type
94 Get V Sensor Warning Struct of Byte Bit definitions of
Sensor Warnings 0 = [default]
→ "Semantics" section
95 Get V Sensor Alarm Struct of Byte Bit definitions of
Sensor Alarms 0 = [default]
→ "Semantics" section
96 Get V Status Extension BYTE Bit-mapped byte
providing additional
status bits Bit description:
0 Reading Invalid
(Logical Inversion of
Reading Valid)
1 Overrange Exceeded
2 Underrange Exceeded
99 Get NV Subclass UINT Defines a subset of
additional attrib-
utes, services and
behaviors. 02 = Heat Transfer Vacuum
Gauge
All Data Type attributes use the enumerated values integer or float
(
→ Appendix A).
The Data Type value will be set automatically based upon the first valid I/O con-
nection established by the device.
If no established I/O connections exist, which include an attribute from this object,
then the Data Type attribute is settable provided that the object is in the Idle State.
Note: Using data type integer in combination with a pressure unit (mbar, Torr or Pa)
will obviously not produce reasonable values below 1.
The Data Unit is only settable in the IDLE state.
2.4.2.2 Semantics of S-Analog
Sensor Instance 1
Data Type
Data Unit