INFICON T3000 Thermal Power Supply - Manual (Page 37)

T3000 Thermal Power Supply instruments
Page 6 - 2 Section 6
Table 6-2 Inspection and Corrective Action
ITEM INSPECT FOR CORRECTIVE ACTION
Connector plugs and buss
bars Loose, bent or corroded
contacts and buss bars.
Damage or improper seating
in mating connector. Clean contacts and buss
bars with solvent moistened
cloth, soft bristle brush, small
vacuum or low compressed
air.
Chassis, fans & extruded
heatsinks Dirt and corrosion Replace damaged or
corroded connectors.
External electrical wiring Broken, burned or pinched
wire. Frayed, worn or
missing insulation Clean with cloth moistened
with soapy water.
External solder connections Corrosion, loose, cracked, or
dirty connections Repair or replace defective
wires.
Dirt and moisture buildup Short circuits, arcing,
corrosion, overheating Clean and resolder
connections.
T3000 enclosure Dirt and corrosion Clean as required with cloth
moistened with soapy water.