INFICON T3000 Thermal Power Supply - Manual (Page 36)

instruments Thermal Power Supply T3000
Section 6 Page 6 - 1 Maintenance
Section 6
Maintenance
6.1 Introduction
This chapter contains preventive maintenance information for the T3000.
6.2 Preventive
Maintenance
Preventive maintenance for the T3000 consists of scheduled inspection and cleaning.
1. Schedule: Table 6-1 lists the preventive maintenance routines and the
recommended performance intervals.
2. Inspection: Table 6-2 lists the visual inspection checks to be performed. It also
indicates the corrective action to be taken.
Table 6-1
Preventive Maintenance Schedule
PREVENTIVE MAINTENANCE
ROUTINE
RECOMMENDED PERFORMANCE
INTERVAL
Inspection Annual
Cleaning As required
WARNING
All maintenance that requires removal of the
cover of the unit should only be done by
properly trained and qualified personnel.
Hazardous voltages exist inside the unit.
Disconnect the supply from the input power
before performing any maintenance.
Service, fuse verification, and connection of
wiring to the chassis must be accomplished
at least five minutes after power has been
removed via external means. All circuits
and/or terminals to be touched must be
safety grounded to the chassis.