INFICON Sensistor Sentrac Hydrogen Leak Detector - Manual (Page 44)

42
ni
n65
e1-a (140
9)
Measuring with Dynamic Measurement Points
If a dynamic number of measurement points is selected, then do the measurement in
the following steps:
1 Press the probe button, or start button on the screen, to begin the first
measurement.
2 Place the probe near the measurement point while the time-staple is moving.
3 You might need to wait until the next measurement. The instrument signals Wait.
4 Repeat the procedure for the next measuring point.
5 When you sum up all the measurements press and hold on the probe button a
short time.
To view specific measurements, press the backward and forward buttons
simultaneously.
If a measurement is to be aborted and restarted, press and hold the probe button a few
seconds. You can also click the Abort button on the screen.