INFICON Sensistor Sentrac Hydrogen Leak Detector - Manual (Page 25)

23
ni
n65
e1-a (140
9)
6 Setup
6.1 Placement of the Sensistor Sentrac
Avoid to place the Sensistor Sentrac close to hydrogen sources such as cigarette
smoke, combustion engines, aluminum machining, lead battery charging stations and,
in some cases, compressed air systems.
6.2 Connect the Sensistor Sentrac
1 Connect the probe to the Sensistor Sentrac using the probe cable. If you have
purchased another type of probe than the Hand Probe P60, contact INFICON for
help. It may require adaptation equipment between samples and instruments.
2 Plug the Power Cable into the power inlet of the Sensistor Sentrac and into the
nearest power socket.
Warning
Make sure all relevant legislation and safety standards are complied with before
putting the Sensistor Sentrac into service.
Notice To disconnect the Probe, hold around the knurled part of the connector
and pull straight out.
Standard cable length is 3 m. Several different cable lengths are available.
See Chapter 17 “Spare Parts and Accessories” on p. 73.