INCRA TS-LS Table Saw Fence - Manual (Page 2)

6 each
3 ⁄ 8 – 16 x 1 1 ⁄ 2 ”
hex bolt
6 each
3 ⁄
8
”
flat washer
6 each
3 ⁄
8
”
lock washer
6 each
3 /
8
– 16
hex nut
2 each
3 ⁄
8
– 24 x 1”
hex bolt
(Delta Unisaw)
4 each
5 ⁄ 16 – 18 x 1 1 ⁄ 2 ”
hex bolt
4 each
5 ⁄
16
”
flat washer
4 each
5 ⁄
16
”
lock washer
4 each
5 ⁄
16
– 18
hex nut

Before using the INCRA TS-LS, read and follow all
of the instructions and safety information in this
manual.

When using the INCRA TS-LS in conjunction with
any other tool, first read and follow all instructions
and safety information in that tool’s owner’s manual.

Never let any part of the INCRA TS-LS interfere
with another tool’s safety guards or other safety
equipment.

Before using your INCRA TS-LS, make sure all
mounting screws are tight and that the black
clamping knobs are securely tightened to the rails.

Always turn off the power and make sure that the
blade is fully stationary before changing the setting
on any part of the INCRA TS-LS.

Always keep both hands behind the fence when
moving the INCRA TS-LS to a new setting.

Before making a cut, always make sure that the
carriage clamp is fully engaged and that the
rail hook thumbscrew is securely tightened.

Use appropriate safety devices. Keep hands clear
of the saw blade! Always use a push stick, rubber
soled push block, or other safety devices to keep
your hands safely away from the saw blade.

Never let the saw blade come into contact with
any part of the INCRA TS-LS or LS Positioner.

Wear safety glasses, hearing protection, and follow
all normal shop safety practices.

Never operate your table saw without a blade guard.
SAFETY
FASTEnERS
(ACTUAL SIZE)
Mounting Bracket Hardware Pack B-01
Note:
Extra hardware is provided in this pack to
ensure compatibility with a wide variety of
table saws. Only four of the bolts will be
used in a typical installation.
Important safety instructions for using the INCRA TS-LS
2 INCRA Woodworking Tools & Precision Rules