beautypg.com

Get set – INCRA IBOX User Manual

Page 8

background image

INCRA IBOX OWNER’S MANUAL

Manufactured by Taylor Design Group, Inc. P.O. Box 810262 Dallas, TX 75381

W W W . I N C R A . C O M

Page 8

Get set…

1. “Kiss” Calibrate

With the positioning lock knob loose, you need to

“kiss” calibrate the IBOX

(YOUR tABLe sAW

OR ROUteR tABLe sHOULD stILL Be

UNPLUGGeD). To do this, slide the IBOX in your

miter channel to a position adjacent to your cutter.

Now hold the red knob as you rotate the silver

micro-adjust knob to move the pin plates. You’ll want

the pin plates to just touch the blade,

Fig. 15 and

Detail 15A. If you are setting up at the router table,

you may need to rotate the cutter by hand to confirm

that the cutter just touches the pin plates. This “kiss”

calibration step zeros the IBOX to the edge of your

cutter. Subsequent adjustments to the pin plates

made by turning the red knob will not alter this initial

calibration.
2. Adjust Pin Plates for test Cut

With the positioning lock knob still loose, rotate the

red knob clockwise to move the nearest pin plate

about 1/8” or more away from the blade,

Fig. 16.

You’ll notice that the pin plates will simultaneously

move away from each other as they move away from

the blade. This is OK. Your “kiss” calibration setting

is automatically retained.

tighten the black

positioning lock knob located on top of the

IBOX fence.
3. Position stock Ledges

Slide the blade side stock ledge to about 1/8” from the

cutter then re-tighten the fasteners.

For reference,

the blade side stock ledge refers to the

stock ledge that is nearest to the cutter

while the pin plate side stock ledge refers

to the stock ledge that is on the other side

of (and nearest to) the pin plates. Slide the

pin plate side stock ledge up to contact the pin plates

and re-tighten the fasteners,

Fig. 17. Slide the IBOX

back and forth in the miter slot to make sure that the

blade is clear of both the pin plates and the blade side

stock ledge.

Fig. 15

“Kiss” Calibrate

3) Rotate

silver knob

until pin

plates

“kiss” the

blade

Fig. 16

Adjust Pin Plates for test Cut

Rotate red knob

clockwise until approx.

1/8” between blade and

closet pin plate

Fig. 17

Position stock Ledges

Slide to 1/8”

from blade and

tighten fasteners

Detail 15A

Blade

should just

touch the

pin plates

1) Loosen locking knob

2) Hold

red

Knob

in place

After adjustment

tighten positioning

lock knob!

1/8” approx.

Slide to contact

pin plate and tighten

fasteners

Blade side

stock ledge

Pin plate side

stock ledge