Stock ledges, blade guards & backing board – INCRA IBOX User Manual

Page 5

INCRA IBOX OWNER’S MANUAL

Page 5

2. Attach IBOX to GlideLOCK™ Miter Bar

Assembly

Position the IBOX fence on the GlideLOCK™ Miter

Bar Assembly with the red knob on the

LeFt end of

the IBOX fence. Insert the (2) #10-24 x 3/8” button

head fasteners through the slotted holes in the fence

and thread into the holes on the GlideLOCK™ Miter

Bar. Don’t tighten the fasteners just yet. Slide the

IBOX along the alignment plate until the tall notch on

the fence is centered on your router’s collet,

Fig. 6 and

Detail 6A. The center is 9/16” from the edge of the

notch if you would like to use a ruler for the alignment.

Make sure that the IBOX is firmly in contact with

the alignment plate on the GlideLOCK™ Miter Bar

Assembly then tighten the (2) button head fasteners to

secure the fence to the bar. If you move the IBOX to

another router table or your table saw, you will need

to reset the Miter Bar’s position as described in Steps

1-2 above for the router table or steps 1-3 on page 3

for the table saw.

Fig. 6

Attach IBOX to Miter Bar

Alignment

plate

2) Secure fence

against alighment

plate and tighten (2)

fasteners

Detail 6A

1) Slide fence to

center tall fence

notch on router

collet

STOCK LEDGES, BLADE GUARDS & BACKING BOARD

In the following steps you’ll add the Stock Ledges, the Blade Guards and the Backing Board. The photos show the

table saw set up but the steps are identical for the router table.

1. Attach stock Ledges

Insert the (2) #10-32 x 5/16” flat head

Phillips screws through the countersunk

holes in each stock ledge and loosely

thread on the #10-32 rectangular nuts.

The raised rim on the rectangular nuts

should be facing the stock ledge. Slide

the rectangular nuts into the T-slot

on the front of the IBOX fence. For

now, align the ends of the stock ledges

with the wide cutout in the fence and

tighten all (4) fasteners,

Fig. 7.

Fig. 7

Attach stock Ledges

Stock ledge

Securely tighten

all (4) fasteners

#10-32x5/16” flat

Phillips with

rectangular nuts

Align ends with

wide cutout in

lower part of

fence