Brother LW6091001 - Manual (Page 63)

1
2
3
4
5
6
7
8
9
59
z
LA
BEL PRIN
TING
Adjusting the Label Length
You can adjust the length of the printed label in levels of -5 to +5.
Press the Setup key to display the setup menu, select "Adjust Length" using the
or key, and then press the OK or Enter key.
Select "Adjust Length" by using the or key, and
then set the value by using the or key.
Press the OK or Enter key to apply the setting.
If necessary, trim the printed label to the desired shape and length using scissors, etc.
Peel the backing from the label.
Position the label and then press firmly from top to bottom with your finger to
attach the label.
Adjusting the Label Length
1
2
3
• Press the Escape key to return to the previous step.
• Press the Space key to set the value to default setting.
• Approximately 1% of the total label length will be adjusted by 1 level.
Attaching Labels
1
2
3
• The backing of some types of tapes may be pre-cut to make it easier to peel the backing.To
remove the backing, simply fold the label lengthwise with the text facing inward, to expose
the inside edges of the backing. Next, peel off the backing one piece at a time.
• Labels may be difficult to attach to surfaces that are wet, dirty, or uneven. The labels may peel
off easily from these surfaces.
• Be sure to read the instructions provided with Fabric Iron-On Tapes, Extra Strength Adhesive
Tapes or other special tapes and observe all precautions noted in the instructions.