GeoDesy FSO GeoData20 series - Manual (Page 54)

54
Enable
– select to enable LEDs on the device. If this option is not selected, then no LED activity will
be visible on the device.
RSSI thresholds
– specify the RSSI threshold at which corresponding LED will switch on.
The Signal LEDs are working only when the connection is established. Therefore, please make
sure all wireless settings are correct and the connection is established.
LAN LED
– select to enable LAN LED. The red LED will be blinking on LAN activity, off – no LAN
connection.
Power LED
– select to enable Power LED. The steady red LED when power is on, off – no power.
7.4.4 Firmware Upgrade
To update your device firmware use the System | Firmware upgrade menu. Press Upload
firmware, select the firmware file and click the Upload button:
Current version
– displays version of the current firmware.
Upload firmware
– click the button to select the new firmware image for uploading it to the device.
The device system firmware upgrade is compatible with all configuration settings. When the device is
Upgraded with a newer version or the same version builds, all the system’s configuration will be
Preserved after the upgrade.
The new firmware image is
uploaded to the controller’s temporary memory. It is necessary to save the
Firmware into the device permanent memory. Click the Upgrade button: