GeoDesy FSO GeoData20 series - Manual (Page 24)

24
IP Settings
When assigning IP address make sure that the chosen IP address is unused and belongs to the same
IP subnet as your wired LAN, otherwise you will lose the connection to the device from your current PC.
If you enable the DHCP client, the browser will lose the connection after saving, because the IP
address assigned by the DHCP server is not predictable.
Method
– specify IP reception method: IP addresses can either be retrieved from a DHCP server or
configured manually:
 Static IP – the IP address must be specified manually.
 Dynamic IP – the IP address for this device will be assigned from the DHCP server. If DHCP
Server is not available; the device will try to get an IP. If has no success, it will use a fallback IP
address (default fallback IP is 192.168.2.66). The fallback IP settings can be changed to custom
values.
IP Address
– specify IP address for device
Subnet mask
– specify a subnet mask for device.
Default gateway
– specify a gateway IP address for device.
DNS server
– specify the Domain Naming Server.
Enable IP alias
– specify the alternative IP address and the netmask for APC unit management.
VLAN to SSID Mapping
Virtual Local Area Networks (VLANs) are logical groupings of network resources.
VLAN to SSID mapping
– specify the VLAN ID for traffic tagging on required radio interface [2-4095].
The Station devices that associate using the particular SSID will be grouped into this VLAN.