Gardman Granite Cobbles - Manual (Page 4)

www.gardman.co.uk
Performance
• Operate in fresh water only
• The pump should be completely submerged during use
• Always submerge the pump before plugging in to electrical supply
• Please wait a short time for the pump to flow correctly as there could be air in the pump and
rubber tube
• If less flow is desired adjust the flow control switch/dial on the pump. Do not let the pump run when
not submerged in water as doing so may cause damage
• A clogged or dirty intake screen will greatly reduce the performance. If the pump is used on a dirty
surface, raise it slightly to reduce the amount of debris in contact with the intake screen
Maintenance
To clean the pump, remove the back cover and the impeller. Use a small brush or stream of water to remove
the debris.
CAUTION: The pump shaft cannot be removed. IF THE PUMP FAILS TO OPERATE CHECK THE FOLLOWING:
• Check the circuit breaker and try another electrical outlet to ensure the pump is receiving power. NOTE:
Always disconnect from the electrical outlet before handling the pump
• Ensure the tube attached to the motor head is free of kinks and obstructions
• Check the front plate to ensure it is not clogged with debris
• Remove the pump front plate to access the impeller area. Turn the rotor to ensure it is not broken
or jammed
• Monthly maintenance will add to your pump’s life. NOTE: Ensure that the power supply lead loops below
the electrical supply. This will form a “Drip Loop” and will prevent water from running down the cord in
the electrical outlet
Motorhead
Impeller Holder
Seal Ring
Front Plate
Suction Bracket
Impeller
Shaft
Regulator
19195AT Granite Cobbles Outdoor Water Feature