Gardman Shimmering Springs - Manual

www.gardman.co.uk
19191AT Shimmering Springs Outdoor Water Feature
Contents
• Top section, bottom section, pump and transformer
Assembly Instructions
• Unpack all items and place on a flat surface
• Feed the long lead from the pump down through the pipe in the centre of the base section (A)
• Connect the rubber tube to the pump and connect the lead from the LED to the extra lead running
from the pump (B)
• Fill the base with water to within 25mm of the top of the pipe. Place the top section onto the base
making sure the pump lies flat in the base and the rubber tube is not kinked
• Connect the long lead from the feature to the transformer (C)
• Insert the plug from the transformer in to the power socket and switch on. If installed correctly water
will start to flow from the feature. Please note: On first use, there may be air in the pump and it may
take a few moments for the water to come through
Please read the assembly instructions and pump instructions carefully prior to installation.
A
C
B