Gardman Tranquil Buddha - Manual

19048 Tranquil Buddha Outdoor Water Feature
www.gardman.co.uk
Water Feature place of purchase (Retailer): Date of Purchase:
Purchase Price:
Please read the assembly instructions and separate pump instructions carefully prior to installation.
Assembly Instructions

Unpack all the water feature components from the packaging and lie on a flat surface.

Attach the pump (2) to the internal rubber tube (1) that is located in the reservoir opening (3) round
the back of the water feature. Lay the pump inside the feature on the base and make sure the tube is
properly connected and is not kinked.

The pump flow can be adjusted by turning the dial (4) which is located on the inlet of the pump.

Connect the two cables (5) & (6) and screw over the plastic collar (7) until secure.

Position the cable through the reservoir opening located on the back of the water feature. Plug the 2
pin connector (8) in to the plug/transformer (9) and tighten the screw collar (10). Do not insert the plug
in to the mains at this time.

Fill the reservoir with water to 3cm (1 ¼”) from the top of where the reservoir compartment begins.

Insert the plug/transformer in to the power socket and switch on. If installed correctly water will start
to flow from the feature. Please note: On first use, there may be air in the pump and it may take a few
moments for the water to come through.