Gardman Smiling Buddha - Manual

www.gardman.co.uk
19192AT Smiling Buddha Outdoor Water Feature
Contents
• Water feature body, cover, pump and transformer
Assembly Instructions
• Unpack all items and place on a flat surface
• Slide the cover out of the back of the base section and put to one side. Feed the cables and rubber
tube out through the hole in the back of the feature (A)
• Connect the lead from the LED to the extra lead running from the pump (B)
• Connect the rubber tube to the pump. Push the pump through the opening on the back of the feature
and stand it on the bottom of the reservoir. Make sure the rubber tube is not kinked (B)
• Fill the feature with water to within 50mm of the bottom of the hole in the rear of the feature. Slide
the cover back into place, feeding the cables into the slot in the left-hand corner of the cover (C)
• Insert the plug from the transformer in to the power socket and switch on. If installed correctly water
will start to flow from the feature. Please note: On first use, there may be air in the pump and it may
take a few moments for the water to come through
Please read the assembly instructions and pump instructions carefully prior to installation.
A
C
B