Gardman Laurel Spills Indoor - Manual

19042 Laurel Spills Indoor Water Feature
www.gardman.co.uk
Water Feature place of purchase (Retailer): Date of Purchase:
Purchase Price:
Please read the assembly instructions and separate pump instructions carefully prior to installation.
Assembly Instructions

Unpack all the water feature components from the packaging and lie on a flat surface.

Take the top part of the feature (1) and attach the pump (3) to the rubber tube (2) that is located on
the underside, and then lay the pump inside on the base of the feature (4). Make sure the tube is
properly connected and is not kinked.

The pump flow can be adjusted with the switch (5) which is located on the inlet of the pump.

Connect the two cables (6) & (7) and screw over the plastic collar (8) until secure.

Position the cable through the cable slot located on the top part of the water feature. Do not insert
the plug in to the mains at this time.

Fill the reservoir with water to 1.5cm (1/2”) from the top. We recommend using warm water to
prevent mineral build up.

Set the top part of the water feature onto the base so it sits level.

Insert the plug/transformer in to the power socket and switch on. If installed correctly water will
start to flow from the feature. Please note: On first use, there may be air in the pump and it may
take a few moments for the water to come through.