Gardman 3 Tier Cascade WF - Manual

19045 3 Tier Cascade Outdoor Water Feature
www.gardman.co.uk
Water Feature place of purchase (Retailer): Date of Purchase:
Purchase Price:
Please read the assembly instructions and separate pump instructions carefully prior to installation.
Assembly Instructions
 Unpack all the water feature components from the packaging and lie on a flat surface. Place the
separate pots (1) in position on top of the feature (2). Be sure to feed the rubber tube (3) attached to
the top pot through the hole in the feature.

Open the reservoir sliding compartment (4) on the rear of the feature and attach the pump (5) to the
rubber tube (3) that is located inside. Lay the pump inside the feature on the base and make sure the
tube is properly connected and is not kinked.

The pump flow can be adjusted by turning the dial which is located on the inlet of the pump (6).

Position the cable through the reservoir compartment located on the back of the water feature. Do
not insert the plug in to the mains at this time.

Fill the reservoir with water to 6cm (2 ¼”) from the top of where the reservoir compartment begins.

Insert the plug/transformer in to the power socket and switch on. If installed correctly water will start
to flow from the feature. Please note: On first use, there may be air in the pump and it may take a few
moments for the water to come through.