Gardman Rattan Tower - Manual

19049 Rattan Tower Outdoor Water Feature
www.gardman.co.uk
Water Feature place of purchase (Retailer): Date of Purchase:
Purchase Price:
Please read the assembly instructions and separate pump instructions carefully prior to installation.
Assembly Instructions

Unpack all the water feature components from the packaging and lie on a flat surface.

Remove the top part (1) of the feature and connect the rubber tube (2) that is located on the
underside in to the opening on the pump (3). Lay the pump inside on the base of the feature (4).
Make sure the tube is properly connected and is not kinked.

The pump flow can be adjusted by moving the dial (5) which is located on the inlet of the pump.

Connect the two cables (6) & (7) and screw over the plastic collar (8) until secure.

Position the cable through the cable slot located on the top part of the water feature under the head
piece. Plug the 2 pin connector (9) in to the plug/transformer (10) and tighten the screw collar (11).
Do not insert the plug in to the mains at this time.

Fill the reservoir in the base with water up to halfway from the top.

Set the top part of the water feature onto the base so it sits level.

Insert the plug/transformer in to the power socket and switch on. If installed correctly water will start
to flow from the feature. Please note: On first use, there may be air in the pump and it may take a few
moments for the water to come through.