Gardman Sandstone Springs - Manual

19047 Sandstone Springs Outdoor Water Feature
www.gardman.co.uk
Water Feature place of purchase (Retailer): Date of Purchase:
Purchase Price:
Please read the assembly instructions and separate pump instructions carefully prior to installation.
Assembly Instructions

Unpack all the water feature components from the packaging and lie on a flat surface.

Remove the top part (1) of the feature and connect the rubber tube (2) in to the opening on the pump
(3). Now locate the rubber tube in to the opening located on the underside of the top part of the feature.
Lay the pump inside on the base of the feature (4). Make sure the tube is properly connected and is not
kinked.

The pump flow can be adjusted by moving the dial (5) which is located on the inlet of the pump.

Connect the two cables (6) & (7) and screw over the plastic collar (8) until secure.

The cable is located through the side of the water feature. Plug the 2 pin connector (9) in to the
plug/transformer (10) and tighten the screw collar (11). Do not insert the plug in to the mains at this
time.

Fill the reservoir with water to 6cm (2 ¼”) from the top of the water feature.

Set the top part of the water feature onto the base so it sits level.

Insert the plug/transformer in to the power socket and switch on. If installed correctly water will start to
flow from the feature. Please note: On first use, there may be air in the pump and it may take a few
moments for the water to come through.