Gardman Lilly Indoor - Manual

19040 Lilly Indoor Water Feature
www.gardman.co.uk
Please read the assembly instructions and separate pump instructions carefully prior to installation.
Assembly Instructions

Unpack all the water feature components from the packaging and lie on a flat surface.

Attach the rubber tube (1) on the underside of the fountain (2) to the pump (3). Make sure
the tube is properly connected and is not kinked.

The pump flow can be adjusted with the switch (4) which is located on the inlet of the pump.

Position the cable through the cable (5) slot at the rear of the water feature (6), and then lay
the pump inside on the base of the feature (7). Do not insert the plug in to the mains at this
time.

Set the fountain top onto the reservoir so it sits level.

Fill the reservoir with water to 1.5cm (1/2”) from the top. We recommend using warm water
to prevent mineral build up.

Insert the plug/transformer in to the power socket and switch on. If installed correctly water
will come out of the nozzle. Please note: On first use, there may be air in the pump and it
may take a few moments for the water to come through.