Gardman Grecian Pouring Bowls - Manual

www.gardman.co.uk
19190AT Grecian Pouring Bowls Outdoor Water Feature
Contents
• Top section, bottom section cover, pump and transformer
Assembly Instructions
• Unpack all items and place on a flat surface
• Place top section onto the base, feeding the rubber tube and cable down into the base (A)
• Slide the cover out of the back of the base section and put to one side. Feed the cables and rubber
tube out through the hole in the back of the feature (A)
• Connect the rubber tube to the pump and connect the LED wires from the back of the feature to the
additional cable with the two connectors. Connect this additional cable to the lead from the pump (A)
• Push the pump and the cables through the opening on the back of the feature. Stand the pump on
the bottom of the reservoir. Make sure the rubber tube is not kinked
• Fill the feature with water to within 50mm of the bottom of the hole in the rear of the feature. Slide
the cover back into place, feeding the cable into the slot in the right-hand corner of the cover
• Connect the lead to the transformer (B)
• Insert the plug from the transformer in to the power socket and switch on (C). If installed correctly
water will start to flow from the feature. Please note: On first use, there may be air in the pump and it
may take a few moments for the water to come through
Please read the assembly instructions and pump instructions carefully prior to installation.
A B C