Gamber-Johnson MCS-1TMRS-CV - Manual (Page 4)

Fig. 6 - Slide the shelf straight into the slides.
With the shelf in position tighten down the nuts and screws attaching the
shelf assembly to the vehicle.
Attach the safety snap pin and lanyard to the side bracket with one 8-32 x
.38 long phillips screw.
Install a shelf support bracket to each side of the shelf assembly with two
10-32 x .38 phillips screw installed from the inside surface.
Using a 9/16" wrench turn the levelers down against the trunk surface until
snug and the weight of the trunk shelf assembly is supported by the
levelers. Tighten the jam nuts.
8-32 x .38 SCREW
SAFETY SNAP PIN
LANYARD
10-32 x .38 SCREWS
SUPPORT BRACKET
LEVELER &
JAM NUT
SH 4 OF 4
FIG. 6