Gamber-Johnson 7160-0201 - Manual (Page 2)

CRADLE, DELL E-64XX & E-64XX ATG
INSTALLATION INSTRUCTIONS
Product Revision Form
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
7160-0201 Rev. D INST-438
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program. The OEM port
replicators used in docking cradles are not warrantied by Gamber-Johnson.
Page
© copyright 2011 Gamber-Johnson, LLC
Figure 2
Loosen and adjust side hook
with 5/32 hex-key wrench
Latch Button
Loosen and adjust side hook
with 5/32 hex-key wrench
2 / 5
Adjusting the Side Brackets
1. After the port Replicator has been installed, open the cradle by pushing the latch button
and pulling the sides outward.
2. Mount the computer onto the Port Replicator. A secure mount is confirmed with an audible
click of the Port Replicator.
3. If a E-6400 or E6410 computer is being used, take off both side hooks and remove the 3/8"
thick spacers. Reassemble the side hooks to the cradle.
4. Close the cradle, adjust the side hooks up or down to align with the computer case.
and secure the mounting screws with a 5/32" Hex-Key Wrench.
Remove Side Spacers if using a
E-6400 or E-6410 computer
Remove Side Spacers if using a
E-6400 or E-6410 computer