beautypg.com

Gamber-Johnson 7160-0408 User Manual

Installation instructions, Product revision form

background image

INSTALLATION INSTRUCTIONS

Product

Revision

Form #

If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868

7160-0408

INTERFACE - TabCruzer / NEC Pattern to

Gamber-Johnson 2.00" x 4.09"

A

INST-561

Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

© copyright 2012 Gamber-Johnson, LLC

Printing Spec: PS-001

4X - .25-20UNC

Washers & Nylok Nuts

7160-0408 Interface Plate

Gamber-Johnson Motion Attachment

w/ 2.00" x 4.09" Pattern

Position Notch

along Top Edge

7160-0408 Interface allows the mounting of Gamber-Johnson TabCruzer or other

device with NEC hole pattern on a Gamber-Johnson Motion Attachment with a

2.00" x 4.09" pattern.

A #2 drive Phillips screwdriver and 7/16" & 11/32" wrenches or sockets are

needed for assembly.

Place the Interface on the Gamber-Johnson Motion Attachment with the small notch

along the top edge. This will allow the TabCruzer to be rotated to horizontal and

vertical positions.

Attach the Interface to the Motion Attachment with (4) .25-20unc Washers and

Nylok Nuts supplied in the hardware bag.

Attach the TabCruzer to the Interface with (3) #8-32UNC x 1.00" Phillips Pan Head

Screws and Nylok Nuts supplied with the TabCruzer (see INST-543 & INST-555).

NEC Pattern