Gamber-Johnson 7160-0215 - Manual

7160-0215
INSTALLATION INSTRUCTIONS
Product Revision Form
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
LED LIGHT - PANASONIC CF19 DOCK 2009 Rev. A INST-449
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program. Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
The LED light for the Panasonic CF19 Dock or CF19 Cradle will provide light for a user.
The light can be attached to either side of the dock or cradle.
Tool Needed
#2 Philips head screw driver
Installation of the LED Light
1. Remove the left or right cable tie holder if present and set aside.
2. Align two holes of the light bracket with two holes on the rear bottom of the dock
or cradle.
3. Secure the bracket using (2) #6-32 x .38 pan head screws.
4. Adjust light to preferred location.
5. Add the previously set aside cable tie holder to the unused hole in the light
bracket.
#6-32 x .38 Pan head screw
Light Bracket
Alternate hole location
Remove cable tie holder
and set aside.
Insert cable tie holder in
hole in light bracket.