Gamber-Johnson 7160-0539 - Manual

Rev.A INST-652
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
Figure 1
the #8-32 nuts
7160-0539
Product
INSTALLATION INSTRUCTIONS
Form Revision
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
Printing Spec: PS-001 Lind Power Supply Mount Assembly
Installing the power supply:
Remove all (4) nuts from Power Supply Mount. 1.
Take plate (15241) off. 2.
Slide power supply under plate (15241). 3.
Reattach plate (15241) back to rest of Power Supply Mount and tighten down 4.
Figure 2
Mounting the bracket to a dock:
Rotate the power supply mount how it is shown in Figure1 (your dock may 1.
vary), using the hardware with the supplied dock,
Tighten down the hardware. 2.
© Copyright 2013 Gamber-Johnson, LLC