Gamber-Johnson 7160-0472-00, 00-P, 00-E, -03, 03-P, 03-E, -04 and -05 - Manual

required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
7160-0472-00, 00-P, 00-E, -03, 03-P, 03-E,
INSTALLATION INSTRUCTIONS
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
INSTRUCTION SHEET - JT-B1 DOCK
Form
© Copyright 2013 Gamber-Johnson, LLC
-04 and -05
Revision
Printing Spec:
This device is a docking station for the Panasonic JT-B1 Toughpad.
PS-001
3.
Product
Installation:
The dock requires 12 volts DC input. Depending on the configuration of the dock power 1.
can be supplied from Lind #PA1220-3910 (Barrel Connector) or Lind #PA1220-
3618(Square Connector) . Connect the appropriate power supply to the dock (Figure 2
and 3)
Connect Ethernet and USB devices to the dock as desired (Figure 2). 2.
Strain relief all cables using the provided cable ties and strain relief points (Figure 1). 3.
Open the dock and mount the dock using the provided M4 hardware. Note: The 4.
mounting pattern is 75mm VESA.
The tablet hand strap should be installed so the "bump" is opposite the docking 5.
connector.
Use:
Open the dock by fully depressing the Lock Button. 1.
Insert the tablet into the dock with the docking connector facing up. Note: The text on 2.
the tablet will be on the left hand side.
Depress the Slide of the dock until the lock engages and a click is heard.
INST-595 Rev.B
Slide
Lock Button
Docking
Connector