Gamber-Johnson 7160-0415 - Manual

INSTALLATION INSTRUCTIONS
Product Revision Form
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
Rev.A INST-564
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
© copyright 2011 Gamber-Johnson, LLC
Printing Spec: PS-001
7160-0415 CF53 Cradle w/PushLock
7160-0415-01 CF53 Cradle w/AutoLock
7160-0123 LED Light Asembly
7160-0124 Screen Support Assembly
Vehicle Mounting
The CF53 Cradle is designed to be used with Gamber-Johnson motion attachments, poles and vehicle bases.
Four .25-20 x .50 long Button Head Screws are supplied in the cradle hardware bag to secure motion
attachments to the bottom side of the cradle.
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
.25-20 x .50
Button Head Screws
Installing CF53 Computer into Cradle
Press the PushLock or turn AutoLock with key, to move the Handle and Rear Hooks back.
With the computer tilted forward slightly, position the computer between the two side tabs and insert the
computer case handle under the Front Restraint.
Lower the back of the computer so all four rubber feet are on the cradle surface and the back edge of
computer case is captured by the rear tabs.
Pull the cradle Handle forward until the Rear Hooks engage the computer case and the Lock catches. Use
the supplied key to lock the PushLock if necessary.
PushLock
or
AutoLock
Handle
Front Restraint