Gamber-Johnson NP-PAN-CRADLE - Manual

INSTALLATION INSTRUCTIONS
Product Date Form #
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
NP-PAN-CRADLE
CF28, 29, 30 & 31 CRADLE
Rev. C INST-213
The NP-PAN-CRADLE is a universal cradle designed to hold the Panasonic CF28, 29, 30 &
31 computers.
Adjusting the hold-down brackets: See figure below
1. Unlock the unit and rotate the wing turn lock 90 deg. in the counter clockwise direction.
The wing turn lock should be in the vertical direction as shown below.
2. Pull the hold-down bracket assemblies outward away from the sides of the cradle to open
the unit. The hold-down brackets should open approximately 1" in both directions.
3. Insert the computer you are going to use into the cradle. The front tab will help you line
up the computer from side to side.
4. Loosen the (2) #6-32unc ny-lok nuts located on the outside of the hold-down brackets.
5. With the computer screen open, push the hold-down brackets back into the cradle. The
upper brackets should be resting on the top of the keyboard surface.
6. Tighten the #6-32unc ny-lok nuts (loosened in step 3) that hold the upper brackets in
place.
7. You are now finished adjusting the hold-down brackets.
Front Tab
Hold-down
Bracket Assy.
Hold-down
Bracket Assy.
Wing turn lock
(shown in unlocked
position)
#6-32unc ny-lok nuts
Upper Bracket
Upper Bracket