Gamber-Johnson 7160-0320 - Manual

INSTALLATION INSTRUCTIONS
Product Revision Form
Rev.B INST-517
Printing Spec: PS-001
BATTERY BRACKET ASSEMBLY
7160-0320
Parts List
(2X) HAND STRAP SPACER
(1X) BATTERY DOOR
BRACKET LH
(1X) BATTERY DOOR
BRACKET RH
(4X) SCREW SPACER
Disassemble CF‐H1 / CF‐H2 Hand Strap
1 Remove Hand Strap Caps from the Computer
2 Using a Phillips Screw Driver remove Hand Strap Screws
3 Remove Hand Strap and Hand Strap Inserts from computer and separate
Assemble Battery Brackets
1 Install Hand Strap Spacers over screw bosses on computer
2 Place Battery Cover Brackets over screw bosses on computer. (See FIG 2 for orientation)
3 Install Hand Strap over screw bosses on computer
4 Insert one Screw Spacer in each screw hole in Hand Strap.
5 Insert Hand Strap Insert into Hand Strap.
6 Using a Phillips Screw Driver install Hand Strap Screws and tighten to 7 in‐lbs
7 Insert Hand Strap Caps into Hand Strap
Notes:
1. A CF‐H1 computer with the battery brackets attached will only fit in the CF‐H1 Wall Dock. It
will not fit into a CF‐H1 Vehicle Docking Station.
2. A CF‐H2 computer with the battery brackets attached will fit in all CF‐H2 Docking Stations.