Gamber-Johnson 7160-0101 - Manual

Rev.D INST-431
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
PS-001 Printing Spec:
Product
7160-0101
INSTALLATION INSTRUCTIONS
Form Revision
LED ASSEMBLY
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
ATTACHING THE LED ASSEMBLY TO A DOCK:
STEP 1. Attach the LED Bracket to the dock with the two #6-32unc X 1/2" long
screws provided in the hardware bag. See Figure 1.
STEP 2. Attach the LED Assembly to the LED Bracket with the two #6-32unc X 1/2"
long pan head screws provided in the hardware bag. See Figure 2.
STEP 3. The LED is powered using the red and brown wires on the light base. It is
designed to operate on 12 VDC.
In a negative ground vehicle:
Connect the RED wire to the positive pole
of the battery or power distribution box. It
is recommended that the supplied fuse
holder and 1 amp fuse be installed on the
RED wire. Connect the BROWN wire to a
suitable chassis GROUND or the negative
pole of the battery.
The LED has three light options: Red,
Red and White, and OFF.
Figure 2
#6-32unc X 1/2" Screws
LED Assembly
Figure 1
#6-32unc X 1/2" Screws
© Copyright 2013 Gamber-Johnson, LLC