Gamber-Johnson 7120-0635 - Manual

Rev.C INST-577
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
NOTEPAD
should appear as shown in Fig. 1.
PS-001
TM
7120-0587 & 7120-0635
INSTALLATION INSTRUCTIONS
V-LT
Revision
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
Product
CAM CLIP CONVERSION KIT
Form
Printing Spec:
TM V & NOTEPAD
This kit contains the components needed to convert the Gamber Johnson Notepad V (7160-0250)
and Notepad V-LT (7160-0402) so that they can be used with smaller notebook and tablet format
computers, without the bulk of the Rear Support/Brace. The kit provides a depth adjustment of
7.2 - 8.1 inch when the Cam Mount Clip is installed facing inward and 8.1 - 9 inch when the Cam
Mount Clip is installed facing outward. The width adjustment, 10.62 - 16.50 inch (for Notepad V)
and 8.2 - 11.8 inch (for Notepad V-LT) remain unchanged. As does the height adjustment of 0 - 1.5 inch.
7120-0587
A 9/64 inch Hex (Allen) wrench will be needed for installation and adjustment.
7120-0587
A 9/64 inch Hex (Allen) with pin wrench / bit will be needed for installation and adjustment.
If attached, remove existing Rear Support/Braces from back edge of cradle. When finished cradle
1/4
Fig. 1
© Copyright 2012 Gamber-Johnson, LLC