Gamber-Johnson 7160-0318-xx-blue - Manual (Page 7)

Panduit # DNF14-250FIB
Quick Disconnect (female)
to red lead from dock.
Panduit # DNF14-250FIM
Quick Disconnect (male)
to red lead from battery.
16 AWG (red wire)
16 AWG (black wire)
Panduit # DNF14-250FIM
Quick Disconnect (male) to
black lead from battery.
Vehicle Battery
Ground to Vehicle Chassis
Connect in-line fuse holder to lead
wire using Panduit #BSN14-C
Butt Splice connectors
Panduit # DNF14-250FIB
Quick Disconnect (female)
to black lead from dock.
DOCKING THE COMPUTER
Shut down the computer. 1.
Make sure the sliding door (located on the back of the computer has been fully opened, exposing the computer's docking 2.
connector. Make sure the Docking Handle is in the Undocked Position.
Set computer in the dock: 3.
a. Hook the front of the computer on the front retainer.
b. Lower the back of the computer onto the Alignment Pins.
c. Lightly press down on the back of the computer to ensure it is fully seated.
Pull the Docking Handle towards the front of the dock until the latch catches (Docked Position). The push button can be 4.
locked for security.
Boot the computer. If the dock is powered, the computer is powered and ready for use. 5.
Caution: Without a computer in place the Docking Handle is locked in the Undocked Position. DO NOT actuate the Docking
Handle without a computer correctly positioned on the dock. Damage may occur.
* Docking station will operate with the computer screen opened or closed.
Sliding Door
Docking Connector
Alignment Pins
Docking Handle in
Undocked Position
Docking Handle in
Docked Position
Pg 7
Dock
Figure 1
- +
10"
Fuse