FasTest RQD Series Rebuild - Manual (Page 2)

RQD
SERIES
REBUILD INSTRUCTIONS
www.fastestinc.com
Roseville, MN
Ph: 1-800-444-2373
Fax: 651-645-7390
PAT PENDING WP115 5/27/2010
LOCATING HOLE
WRENCH FLATS
REMOVE POPPET
ASSEMBLY
HANDLE PINS
(2)
PISTON
BACK PISTON
LARGE SPRING
SLEEVE
DISASSEMBLY:
1) Activate the handle and align the spanner holes of the piston
to the body. Using a spanner wrench to hold the body and
piston then use a wrench on the flats to thread out the
brass back piston. Note that the joint is held by LocTite so
some heat may be applied for ease of removal.
2) Once the brass back piston is removed, remove the spring
and poppet assembly.
3) Remove the handle pins and handle.
4) Remove the piston and spring from the main body assembly.
5) Slide sleeve back to expose snap ring, remove the snap ring
on the front of the main body assembly and slide off the
sleeve. Note the balls will be free so place in a catch basin.
6) Remove the sleeve o-ring.
FasTest, Inc. Product Warranty
FasTest, Inc. warrants its products against defects of workmanship and/or
material for 12 months from the date of the sale by FasTest, Inc. This warranty
is void if the product is misused, tampered with or used in a manner that is not
in accordance with FasTest, Inc. recommendations and/or instructions.
FasTest, Inc. is not liable for consequential or other damages including, but not
limited to, loss, damage, personal injury, or any other expense directly or
indirectly arising from the use of or inability to use its products either separately
or in combination with other products. ALL OTHER WARRANTIES
EXPRESSED OR IMPLIED, WHETHER ORAL OR WRITTEN, INCLUDING
BUT NOT LIMITED TO WARRANTIES OR MERCHANTABILITY OR FITNESS
FOR A PARTICULAR PURPOSE ARE EXPRESSLY EXCLUDED.
Remedy under this warranty is limited to replacement of the product or an account credit in the
amount of the original selling price, at the option on FasTest, Inc. All allegedly defective products
must be returned prepaid transportation to FasTest, Inc. along with information describing the
products performance, unless disposition in the field is authorized in writing by FasTest, Inc.
SMALL SNAP RING
SLEEVE O-RING