FasTest Panel Mount - Manual (Page 2)

INSTALLATION INSTRUCTIONS
Roseville, MN
Ph: 1-800-444-2373
Fax: 651-645-7390
www.fastestinc.com
WP035 10/6/2010
4. Make sure there is no contamination in the I.D. of seat, especially the
o-ring groove.
5. Inspect the Core to ensure the o-ring is free of contamination
and foreign particulates. Lightly lubricate with compatible refrigerant oil.
6. Thread Core into Seat and torque clockwise to 8 ft-lb’s.
Clip Style Panel Mount
1. Cores should remain in protective packaging until assembly
is required to ensure cleanliness and eliminate damage. Just prior to as-
sembly remove the Core from packaging tray.
2. Push the self-locking retaining ring (Backup Clip) onto seat as shown.
3. Braze SEAT ONLY onto tube or valve block before installing/threading
Core into seat.
4. Install seat thru hole in panel up to the Backup Clip. Hole in panel must
be larger then the hex corners.
Clean I.D.’s of Seat
Clean & Lube O-Ring
Backup Clip
Seat
Example: Tube brazed to Seat
Panel
Retaining Ring
Groove
CoreMax Core