EUCHNER EKS FSA with Ethernet Interface - Manual (Page 31)

Manual EKS Electronic-Key Adapter Ethernet
2. Click Configuration.
f The Configuration screen of the EKS web interface is now displayed.
1. Enter the desired IP address and the subnet mask. If the network has a gateway, also enter this information.
2. Click the Send button.
f The following message is displayed: The settings were saved, to apply settings please switch power
off/on…
3. Interrupt the power supply and connect the Electronic-Key adapter again in order to activate the settings.
Information!
The DIP switches S3.1, S3.2, S3.3 and S3.4 must all be set to OFF, so that settings can be made via
the web interface (see DIP switch settings in section 4.4.3).
100420-02-01/09 Subject to technical modifications Page 31/40